Other settings

Smart function key ( key)

The Smart function key ( key) is located
on the bottom of the handset and informs you
with its flashing to allow you to activate the
following features by simply pressing this key.
nWhen the indicator flashes rapidly,
you can:
– Answer the call (outside call, intercom).
(page 21, 24)
– Stop paging.
– Stop the alarm sound. (page 40)
nWhen the indicator flashes slowly in
standby mode, you can:
– Listen to new messages. (page 52)
– Listen to new voice mail messages.
(page 59)
– View the caller list when there are
missed calls. (page 45)
To activate these features, their Smart
function key must be “On”. (page 15)

Using the Smart function key ( key)

When the indicator flashes rapidly/slowly,
press MN.
RThe above features can be activated
depending the situation.
RIf you answer a call using the Smart
function key, the speakerphone is activated.
REven if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
RWhen the unit has new messages, new
voice mail messages, and missed calls, the
unit can be operated to play the new
messages first, play the new voice mail
messages next, and then show the missed
calls.

Setting the Smart function key

The Smart function key for the following
features must be “On”.
–“New message” (Default: On)
–“New VM” (Default: On)
–“Missed call” (Default: Off)
The settings can be set for each handset.
1MMENUN (right soft key) #278
2MbN: Select the desired setting and press
MSELECTN.
R“” is displayed next to the selected
features.
RTo cancel a selected feature, press
MSELECTN again. “ ” disappears.
3MSAVEN a MOFFN
Note:
RIf the indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.

Dialing mode

If you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1MMENUN (right soft key) #120
2MbN: Select the desired setting.
3MSAVEN a MOFFN

Screen saver mode

The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing MN when on a call.
– pressing MOFFN at all other times.
For assistance, please visit http://www.panasonic.com/help 15

Getting Started

TGH26x(en)_1217_ver051.pdf 15TGH26x(en)_1217_ver051.pdf 15 2013/12/17 18:31:472013/12/17 18:31:47