Panasonic KX-TGH260 Intercom, Power back-up operation for landline, Making an intercom call

Making/Answering Calls

2MbN: “Hold” a MSELECTN

3To answer the 2nd call:

Press MCELLN while the 2nd call is being received.

4To hang up the 2nd call and return to the 1st call (landline call), press MOFFN, then press MN.

Answering a 2nd call during a cellular call

1Press MMENUN during a cellular call.

2 MbN: “Hold” a MSELECTN

3To answer the 2nd call:

Press MN or MCELLN while the 2nd call is being received.

4To hang up the 2nd call and return to the 1st call (cellular call), press MOFFN, then

press MCELLN*1.

*1 If you press MCELLN and the selection list is displayed, select the desired cellular line and press MSELECTN.

Intercom

Intercom calls can be made between handsets.

Note:

RWhen paging unit(s), the paged unit(s) beeps for 1 minute.

RIf you receive an outside call while talking on the intercom, the interrupt tone sounds (page 35).

To answer the call with the handset, press MOFFN, then press the corresponding line key.

Making an intercom call

1MMENUN (right soft key) a a

MSELECTN

2MbN: Select the desired unit. a MSELECTN

3 When you finish talking, press MOFFN.

Note:

RYou can also use the MINTERCOMN soft key, if displayed, to make intercom calls.

Answering an intercom call

1Press MN to answer the page.

2When you finish talking, press MOFFN.

Using the Smart function key

Press M N to answer the page.

Power back-up operation for landline

When a power failure occurs, the charged handset temporarily supplies power to the base unit (power back-up mode). This allows you to make and receive landline calls using a handset during a power failure. The base unit will not perform any other functions. However, some functions such as Caller ID and phonebook are available only when using a handset other than the handset supplying power to the base unit. You can program “Power failure” and the default setting is “Auto” (page 37).

Important:

RIf a handset is not placed on the base unit when a power failure occurs, “Base no power Press OFF” is displayed. After pressing MOFFN on the handset, place it on the base unit to start power back-up mode.

RPower back-up mode will not work if the battery level of the power supplying handset is or .

RDo not lift the power supplying handset from the base unit during power back-up mode.

24For assistance, please visit http://www.panasonic.com/help