Panasonic KX-UT113 manual Setting Up the Unit, Making a Call Using a Headset, Start-up menu

Installation and Setup

Using a Headset

For KX-UT133/KX-UT136, if a headset is connected, you must enable Headset mode using the Headset button (flexible button).

To enable Headset mode, press the Headset button (flexible button). When in Headset mode, [SP-PHONE]is used for going on- and off-hook.

Making a Call Using a Headset

1.Press [SP-PHONE].

2.Enter the number you want to call.

3.Press [ENTER], or wait a few seconds for the number to be dialed.

4.To end the call, press [SP-PHONE].

Receiving a Call Using a Headset

1.Press [SP-PHONE].

2.To end the call, press [SP-PHONE].

Note

•For details about connecting a headset, see "Connections (Page 59)".

•For KX-UT113/KX-UT123, the Headset mode is automatically enabled when connecting a headset.

•The Headset button light shows the current status as follows:

Off: Headset mode off

Red on: Headset mode on

•For details about setting a flexible button as the Headset button, consult your administrator or dealer.

Setting Up the Unit

This section explains the settings that you can configure when you start the unit.

Accessing the start-up settings

1.Connect the unit to an Ethernet cable capable of delivering power (PoE compliant), or use an optional AC adaptor to supply power.

2.Connect the unit to the network.

3.On the start-up screen, press .

4.Select the item for the settings you want to configure.

Start-up menu

You can configure the following start-up settings:

1.Information Display (Page 42)

View a variety of information about the unit.

2.Network Settings (Page 42)

Assign an IP address in order to connect to the network and use the unit.

3.Network Test (Page 44)

Confirm the connection of network devices (e.g., the SIP server, routers, switching hubs).

4.ECO Mode (Page 39) Enable ECO mode.

5.Language (Page 41)

If you prefer to use a language other than English, change your language settings.

6.Default Setting (Page 44)

Initialize the unit to reset the settings to their default values.

7.Restart (Page 45)

Restart the unit for new settings to take effect.

8.Firmware version (Page 45)

Check the firmware version of the unit.

Document Version 2011-06 Operating Instructions

69