Panasonic NV-DS60, NV-DS65 Power Supply, Using the AC Adaptor, Using the Battery

1

1

2

3

1

2	2	M-CARD
		CAMERA

OFF

VCR

BATTERY

RELEASE

3

Power Supply

ªUsing the AC Adaptor

1Connect the DC Input Lead to the [DC/C.C. IN] Socket on the Movie Camera.

2Connect the DC Input Lead to the AC Adaptor.

3Connect the AC Mains Lead to the AC Adaptor and the AC mains socket.

≥The AC Mains Lead’s outlet plug cannot be pushed fully into the AC Adaptor socket. A gap will remain as shown

1.

≥Before connecting or disconnecting the power supply, set the [VCR/OFF/CAMERA/M-CARD] Switch on the Movie Camera to [OFF] and make sure that the [POWER] Lamp is not lit.

ªUsing the Battery

Before use, fully charge the Battery.

1Attach the Battery to AC Adaptor and charge it.

≥Since the Battery will not be charged when the DC Input Lead is connected to the AC Adaptor, disconnect them.

≥The [POWER] Lamp and [CHARGE] Lamp lights up, and charging starts.

≥When the [CHARGE] Lamp goes off, charging is completed.

2Attach the charged Battery to the Movie Camera. To Remove the Battery

Set the [VCR/OFF/CAMERA/M-CARD] Switch 2 to [OFF], and while pressing the [BATTERY RELEASE] Lever 3, slide the Battery to remove it.

≥When attaching or removing Battery, set the [VCR/OFF/

CAMERA/M-CARD] Switch to [OFF] and make sure the [POWER] Lamp is not lit.

ªUsing the Car Battery Charger

If you use the Car Battery Charger (VW-KBD2E; optional), you can supply power to the Movie Camera and charge the battery inside your car. For further information, refer to the instruction manual of the Car Battery Charger.

≥Be sure to start the car engine before you connect the Car Adaptor Cord, otherwise the fuse may blow.

≥For other notes concerning this item, see page 46.

10