Panasonic NV-DS65, NV-DS60 Inserting a Button-type Battery, Using the Remote Controller

1

1

2

3

1

15˚ 15˚

15˚ 15˚

ªInserting a Button-type Battery

Before using the Remote Controller, insert the supplied button- type battery.

1While pressing the Stopper 1, pull out the Battery Holder.

2Insert the button-type battery with the imprint (i) facing upward.

3Insert the Battery Holder into the Remote

Controller.

≥When the button-type battery is weak, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.)

≥Make sure to match the poles correctly when inserting the battery.

.....................................................................................................

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.

.....................................................................................................

WARNING

Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100xC or incinerate. Keep the

Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

.....................................................................................................

ªUsing the Remote Controller

1Direct the Remote Controller to the Remote Control Sensor of the Movie Camera and press an appropriate button.

≥Distance from the Movie Camera: Within approximately 5 metres.

≥Angle: Within approximately 15o in the vertical and

horizontal directions from the central axis.

≥The above operating ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.

≥For other notes concerning this item, see page 46.

9