TEMP | LAMP1 | LAMP2 | POWER |
|
|
| D LP |
Powering off the projector
Press the POWER OFF “
” button.
Select “Execute” with 
or 
button and press the ENTER button.
(or press the POWER OFF “
” button again.)
The projection of the image stops, and the power indicator of the main unit lights up orange. (The cooling fan keeps running.)
Wait until the power indicator of the main unit turns to red (i.e., until the cooling fan stops).
Press the “ 
” marked side of the MAIN POWER switch to remove all power from the projector.
Attention • Do not turn the power supply off and then immediately back on again.
Turning on the power supply will not light up the light source lamp if the lamp is in the process of cooling down after turning off the power supply. To light up the lamp, turn on the power supply again when the lamp has been cooled sufficiently. Turning on the power supply with the lamp in the hot condition may shorten the lamp life.
Note • The projector consumes approximately 10 watts of power even in standby mode after the cooling fan stops. (Power indicator lit in red)
•If you
Direct power off function
The power supplied internally causes the cooling fan to continue operating and cool off the lamp when the power has failed or even after the power cord is disconnected immediately after the power has been turned off.
Note • When the lamp has been cooled by the direct power OFF function, it sometimes
takes longer than usual for the lamp to light up again.
•While the cooling fan is operating, do not place the projector inside a box or bag.
•The operation time of the cooling fan will be less if fewer than 2 minutes have elapsed since the power was turned on.
23
