Precautions on handling
Precautions on transport
Make absolutely sure that the lens cap is in place when transporting the projector or carrying it around. Both the projector and the projection lens are
Precautions on installation
Be sure to observe the following precautions when installing the product.
Avoid installing the product in a place exposed to vibrations or impacts.
If the projector is installed in a place where vibrations are transmitted from a source of driving power and others or mounted in a car or a vessel, vibrations or impacts may be transmitted to the product to damage the internal parts, causing failure. Install the product in a place free from vibrations and impacts.
Do not move the projector while it is operating or subject it to vibration or impact.
The service life of its internal motors may be shortened.
Do not install the projector near high- voltage power lines or power sources.
The product may be exposed to interference if it is installed in the vicinity of
Do not place the projector on a vinyl sheet or carpet.
If a vinyl sheet sucked up and blocks the air filter intake port, the internal temperature of the projector may increase, which triggers the protection circuit, turning off the power.
Be sure to ask a specialized technician when to install the product to a ceiling.
If the product is to be installed hanging from the ceiling, purchase an optional hanging attachment (for high ceiling: Model No.
Do not place the projector over 2 700 m (8 881.5') above sea level. When using it over 1 400 m (4 605.3') above sea level, set the “Fan Control1”, described on page 35, to “HIGHLAND”.
Otherwise the life of the product may be shortened.
Disposal
To discard the product, call the dealer or a specialized dealer.
Precautions on use
To view clear images:
•The audience cannot enjoy
•In rare cases, wafture can occur on the screen affected by the warm air from the exhaust port depending on the environment.
Do not touch the surface of the projection lens with bare hand.
If fingerprints or stains are left on the projection lens surface, they are magnified and projected on the screen. Keep your hands away from the lens. Cover the lens with the supplied lens cap when the projector is not used.
Lamp
A mercury lamp with high internal pressure is used for the light source of this product. A
•It may burst with a loud sound or end its life cycle by not illuminating because of given impacts, flaws, or deterioration due to used hours.
•The life cycle of a mercury lamp varies according to the individual difference or conditions of use. In particular, turning the power on and off frequently and/or repeatedly will greatly affect the life cycle.
•In rare cases, it may burst shortly after the first lighting.
•The possibility of burst increases when the lamp is used beyond the replacement time.
Cleaning and maintenance
Be sure to remove the power cord plug from the receptacle before cleaning.
Use soft and dry cloth to clean the cabinet
If stains are hard to remove, use a cloth dampened with a kitchen detergent solution (neutral) and squeezed to wipe the cabinet and finish with a dry cloth. If a chemical wipe is used, follow its instructions.
Do not clean the lens surface with fuzzy or dusty cloth.
If dust adheres to the lens, it will be magnified and projected on the screen.
Use a soft and clean cloth to wipe off dust.
8
