Switching the projector on/off
Power indicator
The power indicator informs you the status of the power.
When the LAMP or TEMP indicator is flashing, you cannot switch on the power. See “TEMP, LAMP and FILTER Indicators” on page 49.
Power indicator
Basic Operation
Indicator status | Status | ||
|
|
| |
No illumination or flashing | The MAIN POWER is switched off. | ||
|
|
| |
| Lit | The MAIN POWER is switched on and the projector is in standby mode. | |
| When the LAMP or TEMP indicator is flashing, not available to switch on the power. | ||
|
| ||
RED |
|
| |
| The power is switched off. (When NETWORK STANDBY in NETWORK menu or IN | ||
| Flashing | STANDBY MODE of AUDIO SETTING in PROJECTOR SETUP menu is set to ON). Press | |
|
| the power button to start the projection. | |
|
|
| |
GREEN | Flashing | The power is switched on and the projector is getting ready to project. | |
|
| ||
Lit | Projecting. | ||
| |||
|
|
| |
| Lit | The power is switched off and the projector is cooling the lamp. The indicator will light or flash, | |
ORANGE | and start the projection after a short time. | ||
| |||
|
| ||
| Flashing | The power is switched on again when cooling the lamp and recovering to projection mode. | |
|
|
|
NOTE:
•If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take a while to start the projection.
•The electric consumption in standby mode is 4 W.