Panasonic PT-LB20V manual Control commands, Cable specifications, Command Control Remarks Contents

Control commands

The commands which the personal computer can use to control the projector are shown in the following table.

Command	Control	Remarks
	Contents
		In standby mode, all commands other than
PON	Power ON	the PON command are ignored.
		BThe PON command is ignored during
		lamp ON control.
		BIf a PON command is received while the
		cooling fan is operating after the lamp
POF	Power OFF	has switched off, the lamp is not turned
		back on again straight away, in order to
		protect the lamp.
AVL	Volume	Parameter
		000-063 (Adjustment value 0-63)
		Parameter
IIS	Input signal	VID=VIDEO	SVD=S-VIDEO
	selection	RG1=RGB1	RG2=RGB2
		NWP=NETWORK (PT-LB20NTU only)
		Callback
	Lamp ON	0 = Standby
Q$S		1 = Lamp ON control active
	condition query
		2 = Lamp ON
		3 = Lamp OFF control active
		Operation will be switched between ON and
OSH	Shutter function	OFF each time the command is sent. Do
		not switch operation ON and OFF after only
		short periods of time.

Cable specifications

(When connected to a personal computer)

At the projector		At the computer
		(DTE specifications)
	1		7
	2		8	Others
	3		3
	4		5
	5		2
	6		6
	7		1
	8		4
			9

ENGLISH-65