[POSITION] menu
ENGLISH
- 63
Settings
[WSS]
In the European broadcasting system, if the input
signal contains an identication signal, WSS
automatically switches the aspect ratio to the required
setting. ( page 61)
Switch settings Switch settings
[ON] Switch automatically
[OFF] Do not switch automatically
Note
zAspect ratio switches only in the case of these input
signals: PAL/625i (576i)/625p (576p)
[OVER SCAN]
If the 4 edges of an image are partly dropped, you can
use this function to adjust and project it properly.
Shrink image Enlarge image
zSetting range: 0 to +10
Note
zCOMPUTER signal (exc. movie based signals) is not
supported.
[KEYSTONE]
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can correct the keystone vertically.
Image Operation
zSetting range: −32 to +32
Note
zYou can correct the distortion ± 30 degrees from the
vertical plane. However, if there is overcorrection, the
image quality may deteriorate and become blurry. For a
better quality image, installing the projector with minimum
distortion is recommended.
zWhen adjustment with [KEYSTONE] carried out, the
vertical center of the screen and the lens need to be
realigned.
zThe result of the keystone correction will affect the size of
the image.
zKeystone correction does not function on the menu
screen.
zSome distortion may occur due to lens shift adjustment.
zThe result of the keystone correction may affect the
aspect ratio.
zWhen adjustment is performed with keystone correction,
the parallax adjustment result set in the [3D VIEWING
MONITOR] is discarded, and the parallax adjustment
function is disabled.
[AUTO SETUP]
COMPUTER IN (RGB) signals only (exc. movie based
signals)
When you select [AUTO SETUP] and then press the
<ENTER> button, [H-POSITION], [V-POSITION],
[DOT CLOCK], and [CLOCK PHASE] are adjusted
automatically in accordance with the input signal.