Panasonic PV-DV101 manual Before you begin, To adjust the volume

You can also use the LCD monitor to playback your recording.

VOLUME KEY

1LCD-OPEN

Button _

\

2REWIND/

4STOP SEARCH 3PLAY Button Button Button

180 °

-Bui_t-in

Speaker

You can place the Palmcorder on a table, etc. for viewing. Rotate the LCD Monitor 180° and swing it up against the Palmcorder body as shown.

Jack

_-Before you begin

Connect the Palmcorder to a power

source. (See pages 11, 12.) insert a recorded cassette.

L* Set POWER to VCR.

1 Press LCD-OPEN to unlock the LCD

2 monitor and swing open.

Press REWIND/SEARCH to rewind the tape.

Press PLAY to start playback.

To adjust the volume:

AHold down VOLUME KEY until the volume setting screen appears.

(See page 20).

BRotate VOLUME KEY to adjust the volume of the built-in speaker. To remove the volume setting screen, hold down VOLUME KEY again.

•Adjust the picture on the LCD monitor if needed. (See page 23.)

Press STOP to stop playback.

•When the tape reaches its beginning during rewind or rewind search, it will stop automatically.

•If you press PLAY for more than 5 seconds, the Patmcorder will go into Repeat Playback mode when the tape reaches its end. The letter "R 1>" will appear in the EVF and LCD monitor.

To exit the Repeat Playback mode, turn the Palmcorder OFF.

•When a lape recorded in LP mode on another digital video camera is played back on this unit, the picture may appear mosaic.

•Using the LCD monitor reduces battery operating time.

*You can connect earphones (not supplied) to the PHONE Jack.

27