You can control any two Panasonic Palmcorders with one Remote control
(Optional, page 49). In order for the remote to distinguish between the two units, it is necessary to set one of the Palmcorders to VCR 2. On the remote, press VCR 1 or VCR 2 to control the desired Palmcorder.
o,=o/ i
gLoL__J
Set the POWER to VCR or CAMERA.
o The POWER Lamp lights red.
•Be sure POWER is fully turned to VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to select
screen or_ | in lhe |
VCR mode menu screen, then press JOG KEY to display the CAMERA
For VCR 2: _=: Press these
buttons at the same time.
• When the Palmcorder
For VCR 1: "Press these
buttons at the same time.
and remote are
"11" Rotate JOG KEY to selectS,
and then press JOG KEY to select
VCR 2. (See pages 16_ 17.) Leave the other Palmcorder set to VCR1.
5 Set the Remote Control (Optional,
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE (REMOTE)" will appear.
REMOTE
page 49) to VCR 1 or VCR 2 to correspond with the Palmcorder you wish to control. (See above left.)
•After replacing the Remote Control Battery, the remote wilf default to VCR 1.
|
| Insert a slender pointed object, such as the tip of a ball- | |
| A | point pen into the slot so that it fits into the hole (as shown | |
| A). Then, while sliding to the right, pull the Battery Tray out | ||
|
| ||
|
| with your fingernail. | |
|
| Insert the battery into the Battery Tray with the (_ mark | |
O |
| facing | down. |
| Do not reverse the polarity. | ||
|
| Insert | the Battery Tray. |
|
|
| i |
Replacebattery withPanasonic PART NO. VSBW0004 (CR2025) !
only. Use of another battery may present a risk ol tire or explosion. Caution: battery may explode ilmistreated. Dispose of usedbattery properly, Keep away from children. Donot recharge, disassemble
or dispose of in fire. | J |
26
