Panasonic PV-DV101 manual SourcePlaying Palmcorder, Before you begin, Lvt., 1i.rA,,it ,IML.,!I

Source(Playing) Palmcorder

,-Before you begin

•Connect both Palmcorder and VCR to their power sources.

•Connect the Palmcorder to a VCR as illustrated left.

•Turn ON both units.

•Set the recording VCR's Input Signal

Selector to LINE,

•Set the Palmcorder POWER Switch to VCR.

JT 1 Insert a pre-recorded tape

into the source (playing) Palmcorder and a blank tape, with record tab in place, into the target VCR (Recorder).

			TV	2 Press PLAY on the Palmcorder.			When
(Supplied)		(To	View)	the tape reaches	the	point you want to
				start dubbing, press		PAUSE.
Cable (not		Connecting		Place the VCR into RECIPAUSE
	CabLe			mode. (See VCR	manual)
supplied)	(not	supplied)
	Audio	In	Video In	4, Simultaneously,	press PAUSE		on
				both units to begin copying.
To Audio In
			R_cording5	Press STOP on both units when
				copying is completed.		•

:R (Rear)

I_FIF4

			S-Video In
To Video In	To S-Video	In
	(If there is S-Video In)
!Lvt[.], 1i(.'rA,,_it ,IML.],!I		}1	I

•Turn the TV ON and select its VCR channel (either CH3 or CH4).

•Set the VCR/TV Selector on the recording VCR to VCR.

•For technical reasons, dubbing a tape may reduce its quality.

•Press DISPLAY ON TV on the Palmcorder

remote control (optional, page 49) to eliminate EVF!LCD Monitor indications.

•If the Time Code is displayed in the EVF or LCD monitor, it cannot be reset.

•Only the DATEFrtME, when displayed, wil be recorded on the tape.

_bU_ CAUTION:	...............	!
authorized	exchanging and/or
pying of copyrighted recordings may		J
copyright	infringement.

43