Panasonic PV-DV101 manual o.2 AI, AMNU Button

4, 5PAUSE Button

To listen to the desired audio sound, set the AUDIO setting of the VCR mode MENU (see page 17) as follows:

AUDIO'The following selections are available for 12 bit AUD!O dubbed

recordings only (sound recorded in SP mode only).

Set this position to listen to the ST 1 original sound.

ST 2 Set this position to listen to the audio dubbed sound.

Set this position to listen to both

MIX the originat sound and the audio dubbed sound.

I I_r_JL'_l

•16 bit dubbed sound completely erases the original 16 bit recorded sound.

•If you dubbed using 12 bit AUDIO recording and then selected AUDIO-MIX in the menu for playback, the sound will be stereo regardless of the AUDIO-OUT setting.

•If you recorded in LP mode, you cannot use the A.DUB feature.

You can set an automatic Dubbing stop point.

_J

o.2 ]AI

DRESET i

Button

AM_:NU Button

Press PAUSE to start Audio Dubbing.

•Connect the Palmcorder to the TV in order to monitor the sound.

(See page 31 .) A.ouhJ

Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format,

INCOMPATIBLE

TAPE

Press PAUSE to stop Audio Dubbing.

•If the microphone used for dubbing gets too near the speaker of your TV,

a howling noise (feedback) may occur.

*if the tape position is in or was started in a blank section, you cannot use the A.DUB feature.

A Press MENU to display the VCR menu

B creen.

Rotate JOG KEY to select_

_J-_, and then press JOG KEY to display the DISPLAY SETTING

Cmenu.

Rotate JOG KEY to select r_,

and then press JOG KEY to set to

O EMORY.

Press MENU two times to exit MENU

mode. Then, press RESET on the remote control to reset the Counter

Memory to M 0:00:00.

Now, rewind to the editing start point, and continue with steps 2-5.The tape will now slop automatically at "M 0:00:00".

42