Panasonic PV-DV101 manual Recording Palmcorder, Pause, Palmcorder and set Power to VCR

High quality digital4o-digital copying can be accomplished if both Palmcorders

incorporate the DV Input!Output (i.LINK) Connector (DV interface cable (LLINK) is not supplied).

Source (Playing)

Palmcorder

DV Input/Output

.LINK) Connector

Recording

Palmcorder

I

DV Interface Cable (i.LINK)

(O t onal)	3, 4, 5
6STOP 3, 4	PAUSE
Butt_	tt°n

4 RECSutton

_ 4REC Button

3,4,5	-3, 4
	PLAY Button
PAUSE
Button

-Before you begin

•Connect both Paimcorders to their power sources.

•Connect the two Palmcorders using th DV interlace cable (LLINK)

(4-pin to 4-pin).

•Turn both Palmcorders ON.

1 Insert a pre-recorded tape into the source (playing) Palmcorder, and set

POWER to VCR.

2 Insert a blank tape with the record

tab closed into the target (recording)

Palmcorder and set POWER to VCR.

Press PLAY on the source Palmcorder. When the tape reaches the point you want to starl dubbing, press PAUSE.

4 Hold down REC and press PLAY on

the target (recording) Palmcorder or on the remote control (optional, see page 49).

Press PAUSE to pause the tape at the starting point of the dub.

5 Simultaneously, press PAUSE on

both units to begin dubbing.

Press STOP on the recording unit, and then press STOP on the playing unit to end dubbing.

•When two Palmcorders are used for dubbing, it is recommended thal the remote control VCR1 or VCR2 setting be used to avoid improver operation.

•When two Palmcorders are connected using the DV interface cable (i.LINK) (not supplied), a Video Editing Controller cannot be used.

•Do not connect both an S-Video Cable or A/V Cable and a DV Interface Cable (i.LINK).

r CAUTION:			...........m
nauthorized	exchanging	andtor	I
opying of copyrighted recordings may I
e copyright	infringement,
	,,m ,,,H	,	r

44