•if the Palmcorder is connected to a power source, the cassette can be inserted and
ejected without turning the Palmcorder
on,
1TAPE EJECT
_,_
3PUSHTO _% | I_I |
CLOSE | ! FI_ |
Cassette Compartment Cover
Connect the Palmcorder to a power
Before you begin] source. (See pages 11, 12.)
1 Slide TAPE EJECT to open the Cassette Compartment Cover,
2insert a cassette record tab up, window side facing out.
Press PUSH TO CLOSE mark to close the Cassette Compartment Cover.
•To remove the cassette...
Slide TAPE EJECT to open the Cassette Compartment Cover and pull the cassette tape straight out.
Hint to locate recording position when inserting cassette
•When you insert a partially recorded cassette, use the Edit Search Function (see page
24)to visually confirm the point at which you want to start a new recording. EspecialLy advisable when you want to add a recording to a tape that is already full
for tape insertion or ejection. Loosen hand strap if necessary.
ll hand strap is tight it may prevent Cassette Compartmenl Cover from fully opening NoteWhen inserting the cassette, make sure it faces in the right direction and then push in J
completely....................
To brighten the natural colors in a scene.
•Using the light will reduce battery operating time.
•Be sure to provide
adequate ventilation if using Light in a hot environment for an extended period.
•Be sure LIGHT is set to OFF when not in use.
•Do not attempt to lift or carry the Palmcorder by holding the Enhancement Light.
•if _ight bulb needs to be replaced, take
Light to your nearest authorized servicenter.
| "t |
•Connect the Palmcorder to a power source. (See pages tl, 12,)J
•Set POWER to CAMERA.
Slide Light into the
Be sure it locks into place.
Press LIGHTto turn 2LIGHT Button
ON or OFF. | _=_ |
LIGHT RELEASE Button
To remove the Light:
PreSS LIGHT RELEASE and slide the Light out of the mount.
Caution;
This light becomes hot during operation. Make sure nothing covers the Light during operation.
7
