Other information
Notes on “To connect bi-wire speakers”
•
•HF and LF stand for high frequency and low frequency, respectively.
Notes on “Using surround speakers wirelessly with
•Audio output changes as follows when you use surround speakers wirelessly (➔ page 23).
-The maximum number of playback channels is 7.1. (2 sets of
-See
To perform the auto speaker setup using the supplied setup microphone
Insert digital transmitter before performing the setup. Settings made with the setup microphone are cancelled when you insert or remove the transmitter after performing the setup.
Audio signal displays
| DIGITAL INPUT | |
ft | DTS | |
kHz | DIGITAL EX | EX |
MHz |
|
|
DIGITAL
Dolby Digital decoder is being used.
DIGITAL EX
Dolby Digital EX decoder (Dolby Pro Logic 
decoder) is being used when the input signal is Dolby Digital
(Displayed only when you connect one surround back speaker.)
EX
Dolby Digital EX decoder (Dolby Pro Logic 
decoder) is being used when the input signal is DTS
(Displayed only when you connect one surround back speaker.)
PL 
Dolby Pro Logic 
decoder is being used.
PL 
The display informs Dolby Pro Logic 
(the Dolby Pro Logic 
decoder) is used on
Digital signals that can be played on this unit
•Depending on the connected equipment, the playback condition differs. (Playback may be impossible if not supported.)
See operating instructions of playback equipment for more information.
•See “Glossary” (➔ page 52) for more detailed information on each signal.
Dolby Digital (including Dolby Digital Surround EX, Dolby Digital + and Dolby
TrueHD)
DTS (including
PCM
CD, DVD audio etc.
•This unit’s HDMI terminals and COAXIAL DIGITAL IN terminal can play up to 192 kHz and OPTICAL DIGITAL IN terminals can play up to 96 kHz.
•Frequencies appear on the display when the unit receives
input signals transmitted at the frequencies of 88.2 kHz, 96 kHz, 176.4 kHz, and 192 kHz
.
•When you make HDMI connections, the
DTS
DTS decoder is being used.
DTS 96/24
DTS 96/24 decoder is being used.
NEO:6
DTS NEO:6 decoder is being used.
SFC
SFC matrix function is being used.
Notes on “AUTO SPEAKER SETUP”
•Speaker placement, speaker directions and other conditions may prevent correct setting.
•The unit sets the lowpass filter frequency at the value of the speaker capable of reproducing the lowest frequency signal among speakers judged as “SMALL ”.
•When left and right speakers differ in size, they are set as “SMALL ”.
•When surround speakers and surround back speakers differ in size, they are set as “SMALL ”.
•Left and right front speakers are set as “LARGE ” even if their size is “SMALL ” when you perform the auto speaker setup without connecting the subwoofer.
•The unit does not detect or correct polarity of left and right front speakers when you select “YES ” in “Making
•HDAVI Control (➔ page 32) does not work during the auto speaker setup.
•The auto speaker setup is unavailable while muting (➔ page 31) is on.
•The unit sets at 15 meters (45 feet) the distance of speakers located more than 15 meters (45 feet) away from the seating area. The set distance is displayed as “OVER ” (➔ page 37).
•Speakers whose polarity was automatically adjusted are displayed with “– ” such as “L 3.0 – ” (➔ page 37).
50
RQT9223
