Manual tuning
“TUNED” is displayed when a station is tuned.
“ST” is displayed when a stereo FM broadcast is tuned.
Tuning directly using the numbered buttons
1.Press [FM/AM] to activate the radio.
2.Press [FM/AM] to select “FM ” or “AM ”.
3.Press [DIRECT TUNING, DISC] to select Direct Tuning Mode.
4.Press the numbered buttons to enter the
frequency.
e.g. FM 107.9 MHz,
Press [DIRECT TUNING, DISC] → [1] → [0] → [7] → [9].
•If you do not press a button while the cursor is flashing, the display returns to the frequency being received.
•If the frequency has not been input correctly, “ERROR ” will be displayed.
Using the unit
1.Turn [INPUT SELECTOR] to select “FM ” or “AM ”.
2.Press [TUNE 2 or 1] to tune in a station.
Using the remote control
1.Press [FM/AM] to select “FM ” or “AM ”.
2.Press [t] [y] to tune in a station.
g Automatic tuning
Hold down [TUNE 2 or 1] on the unit or [t] [y] on the remote control until the frequency begins to scroll.
•Tuning stops when a station is found.
•Tuning may stop if there is interference.
Note
•To cancel during auto tuning, press [TUNE 2 or 1] on the unit or [t] [y] on the remote control.
Reducing excessive noise
During FM stereo reception
You can improve FM reception by switching reception to monaural.
1.To enter the SETUP (➔ page 36)
2.Press [e][r] to select “TUNER ”, and press [OK] to confirm.
3.Press [e][r] to select “FM MODE ”, and press [OK] to confirm.
4.Press [e][r] to select “MONO ”, and press [OK] to confirm.
•When this is set, “MONO” appears on the display.
•Select “AUTO ” to cancel.
5.To finish the setting (➔ page 36)
1. To enter the SETUP (➔ page 36) | Operations | |
During AM reception |
| |
When there is a lot of noise interference with an AM broadcast, |
| |
try switching to this mode. |
| |
2. Press [e][r] to select “TUNER ”, and | Radio | |
press [OK] to confirm. | ||
| ||
3. Press [e][r] to select “BEAT PROOF ”, |
| |
and press [OK] to confirm. | the | |
4. Press [e][r] to select “MODE 1 ” or | ||
to | ||
“MODE 2 ”, and press [OK] to confirm. | ||
Listening | ||
Factory setting: MODE 1 | ||
5. To finish the setting (➔ page 36) | ||
| ||
Note |
| |
• Select “MODE 1 ” or “MODE 2 ” according to the improvement |
| |
of sound. |
| |
FM frequency step |
| |
If the correct FM frequency cannot be tuned in, change the |
| |
frequency step to suit your area. |
|
1.To enter the SETUP (➔ page 36)
2.Press [e][r] to select “TUNER ”, and press [OK] to confirm.
3.Press [e][r] to select “FM STEP ”, and press [OK] to confirm.
4.Press [e][r] to select “100 ” or “200 ”,
and press [OK] to confirm.
Factory setting: 200kHz
5. To finish the setting (➔ page 36)
Note
•When the frequency step is changed, the previously memorized preset stations are initialised to the settings made at the time of shipment.
49
RQT9223
