Panasonic TG2258PW operating instructions Troubleshooting, General

			Troubleshooting
General
Problem			Cause & Remedy
The unit does not work.			• Check the settings (p. 8–9).
			• Check whether the dialing mode setting is
			correct (p. 13).
			• Charge the battery fully (p. 8).
			• Clean the charge contacts and charge again
			(p. 9).
			• Install the battery properly (p. 8).
			• Place the handset on the base unit and
			unplug the AC adaptor to reset it. Plug in, and
			try again.
			• Re-install the battery (p. 8) and charge it fully.
The unit does not announce			• The handset and base unit ringer volumes
the displayed caller’s name.			are OFF (p. 17).
			• The Talking Caller ID feature is OFF (p. 15).
The unit does not announce			• Name pronunciation may vary. Name
the displayed caller’s name			pronunciation quality is based on names
properly.			most commonly used in the United States.
			• The unit will announce each letter of
			abbreviations, such as Co., Inc., etc.
			• Caller ID service supports names of up to
			15 letters. If the caller’s name has more than
			15 letters, the name will not be announced
			correctly.
Previously programmed			• If a power failure occurs, programmed
information is erased.			information may be erased. Reprogram if
			necessary.
“Recharge battery” is			• Charge the battery fully (p. 8).
displayed, “	” flashes or
the unit beeps intermittently.
You charged the battery fully,			• Clean the charge contacts and charge again
but “Recharge battery” is			(p. 9).
still displayed and/or “		”	• Install a new battery (p. 8).
continues to flash.
The IN USE/CHARGE			• This is normal.

indicator light does not go out after the battery has been charged.

Useful Information

For assistance, please call: 1-800-211-PANA(7262)

57