OPERATION

Camera selection and alarm operations are made on the front panel of the unit or WV-CU360C System Controller.

Camera Selection

Front Panel Operation

You need to remove the front cover loosening the screw with a screw driver before starting operation.

Press a camera number button.

1

2

3

4

The selected camera picture is displayed on the moni- tor connected to the SPOT OUT terminal on the rear of the unit.

Alarm Operation

Alarm Input

An alarm arises in the following cases.

Terminal alarm

A sensor input is supplied to the unit telling that a change has been detected.

Site alarm

A camera detects motion change in video (VMD, Video Motion Detection).

Processing

The spot image changes to that of the alarm activated camera when ALARM MODE is set to ON in the setup.

The camera moves to the preset position.

“ALARM ***” blinks overlaid on the spot image when ALARM DISPLAY is set to ON.

ALARM 001

• The alarm indicator blinks.

WV-CU360C Operation

Enter a camera number with numeric buttons, then press the CAM/SET button.

CAM

SET

The selected camera picture is displayed on the monitor connected to the SPOT OUT terminal on the rear of the unit.

Alarm Output

The alarm activation is informed to the connected peripher- als via the DATA terminal or ALARM/REMOTE terminal when the terminal is set to the alarm output mode. Output duration is specified with the ALARM OUTPUT setup.

Digital Disk Recorder enters a specific recording mode.

Video Multiplexer changes pick-up frame rate and frame order.

System Controller makes the alarm indicator blink on the controller.

28

Page 28
Image 28
Panasonic WJ-MP204C manual Camera Selection, Alarm Operation