Panasonic Explore the Features and Functions of the WJ-MP204C Switch Operating Controls

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

■Front View

q w e r t

POWER	UNIT			ALARM			ALARM
	8	0	2
	9		1	RESET	SUSPEND SET UP
	7		3				ALARM SUSPEND
	6	5	4		SET	ESC
ON
OFF	1			2	3	4

Data Multiplex Unit WJ-MP204C

!2

y u i o !0 !1

qPower switch and power Indicator (POWER ON OFF) To turn on or off the power of the unit, press the switch. The indicator is lit while the power is supplied.

Note: Use the switch protector (supplied) to avoid acci- dental power-off of the unit.

tSetup/escape button (SETUP/ESC)

Holding down this button opens or closes the setup menu.

In the setup operation, pressing this button returns to an upper layer setup menu.

yDown/1 button (C)

Selects camera #1 in normal operation.

Moves the cursor downward in the setup operation.

SWITCH PROTECTOR

uUp/2 button (D)

Selects camera #2 in normal operation.

Moves the cursor upward in the setup operation.

wUnit number switch (UNIT 0-8)

This switch specifies the WJ-MP204C unit number in a PS • Data protocol system, or camera unit numbers in the Camera Communication Protocol system. Refer to page 15 for more information.

eAlarm reset button (ALARM)

This button resets the activated alarm. When this button is pressed, the alarm indicator turns off, alarm display “ALARM ***” on the monitor disappears, alarm status output signal turns inactive on the rear, and an alarm reset pulse is supplied on the rear.

Note: “***” is a camera number.

rAlarm suspend/set button (SUSPEND/SET)

In normal operation, pressing this button suspends the activated alarm mode until it is pressed next.

In the setup operation, pressing this button confirms the presently selected parameter or opens a submenu.

i–/3 button (–)

Selects camera #3 in normal operation. Decrements the parameter in the setup operation.

o+/4 button (+)

Selects camera #4 in normal operation. Increments the parameter in the setup operation.

!0Alarm indicator (ALARM)

This indicator blinks when an alarm is activated, changes to steady light when the preset time elapses, and turns off when the alarm is reset.

!1Alarm suspension indicator (ALARM SUSPEND)

This is lit while the alarm is suspended.

!2Front cover

Put the cover and fix it with the screw on the front panel when these buttons are not required.

7