~3/8X 3"
L
Step 21
A.
*Att(]ch eight PARAOLIDESTRIPS (50) to the PRESSBACKSUPPORT(5) using the following steps: *Thoroughly clean all surfaces where the PARAGLIDE~;TRIPS (50) ore "~o be attached.
*Remove the PARAGLIDESTRIPS from the paper backing and firmly apply them fo the surfaces.
*SECURELYassemble one 5/8 IN. SPRING PIN ASSEMBLY(49) to the SPRING PIN HOUSING,
the PRESS BACK SUPPORT(5) | as shown. (!!! | IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING | ||||||
ASSEMBLYSECURELY.) |
|
|
|
|
|
| ||
*SECURELY assemble | two | 5 IN. | WHEELS(54) | ~o | the | PRESS BACK SUPPORT(S) as | shown on drawing, | |
using two 5/8 | X | IN. | BOLTS (75), | two | 5/8 | IN. WASHERS(69), and two | 5/8 X 1/4 | |
SPACERS(96). | (IF | THE WHEELSDO NOT ROTATE FREELY AFTER THE BOLTS ARE TIGHT, | ||||||
REMOVEWASHERS.)
B.SECURELYassemble the SEAT PAD (.51) to the ADJUSTABLEPRESSSEAT (14) us shown, using 3/8 X
C. Pull buck the SPRING PIN (49) on the PRESSBACK SUPPORT(3) and slide flqe ADJUSTABLEPRESS SEAT (14) in~o the RECEIVING WELL. Engage the SPRING PIN (49) into one of the adiusfmenf holes. Secure the ADJUSTABLEPRESSSEAT (14) in place with one THUMBSCREW(46).
D.SECURELYassemble the BACK PAD (32) to the PRESSBACK SUPPORT(12), using
3/B X ..5 | IN. BOLTS (73), | two | 3/8 IN. | LOCK WASHERS(70), | und two | 3/8 IN. | WASHERS | I |
i | 1/2 I | 1/2 | I | in I | '1 | 1/2 | I | |
0 | 1 | } i | I. | I,,,I,,, |
|
| I_~ | 6 |
I= |
|
|
| 5 |
|
21
