Paradise 205486 REV F Options menu, Fault Setup sub menu, Aux. Action, Aux. Check, Backup, Reset

11.1.1.8 Fault Setup sub menu

This menu allows the user to customize Auxiliary fault setup.

Aux. Action

Allows the selection of the final effect of the auxiliary fault on an SSPA operation. Selection: Fault (Major Fault), Fault + Mute, Alert (Minor Fault).

Aux. Check

Allows the user to select the fault-triggering event. Logic High – fault occurs on “open” unconnected state of auxiliary input line. Logic Low – fault occurs on “close” shorted to ground state of the auxiliary input line. Ignore – allows user to disable auxiliary fault checking.

Options menu

This menu makes available functions to backup or restore settings.

Backup

Allows the user to create a backup of all settings to nonvolatile memory.

Restore

Restores saved settings, either those from a previous backup (User), or to those as shipped from the factory (Factory).

Reset

Allows the user to remotely reset the SSPA controller card MCU, to allow the SSPA to apply new communication settings. The aftermath of the action depends on the selection which been made prior reset. If the SSPA is in Terminal mode protocol, communication with the unit may be reestablished after 5 seconds from the reset time. If the SSPA is configured to be a part of a 1:1 redundant system, the reset will cause the SSPA to go offline.

108 205486 REV F Operations Manual, HPA2, Compact Outdoor SSPA