Paradyne 1740 SHDSL manual Console Access, VT100 Compatible Terminal, Console Port Cable

1740 SHDSL 2/4-Wire Router User’s Guide

CHAPTER 16 Console Access

To access the device via the console port the following are required:

VT100 Compatible Terminal

This terminal is essential to perform the initial configuration of the router. This is normally a terminal with a VT100 emulation program, such as Telix or HyperTerminal Edition 5.

Console Port Cable

An RS-232, DB9-to-DB9 straight-through cable is only required if you need to connect the device to a VT100 terminal or equivalent. The cable is not supplied with the SHDSL router.

16.1.1Login

For access by console, the console PC should be installed with a standard VT100 emulation program, such as HyperTerminal 5 or Telix. You must connect the router to a PC using a serial cable. The following steps describe how to establish the console session.

STEP1: Run a standard VT100 program such as HyperTerminal (Ver. 5 is recommended), or Telix in the local terminal and select an open com port.

STEP2: Enter the following port settings:

Baud rate: 9600

Data bits: 8

Parity: none

Stop bit: 1

Flow control: none

STEP3: After the session parameters are set up, press the Enter Key. You will be requested to enter the user name and password.

STEP4: After successfully logging in, the main menu will appear.

66 July 2004 1740-A2-GB20-00