Paradyne 6212 manual To configure STP parameters, Enable/Disable STP

5.11.4 To configure STP parameters

STEP 1: Click on the Spanning Tree tab at the top of the Bridging screen.

STEP 2: Click on the Configure Port button.

STEP 3: Configure the parameters.

STEP 4: Click on the Apply button.

5.11.5 Enable/Disable STP

To enable or disable an STP entry, select the entry and then click on the Enable or Disable Button, located at the bottom of the Spanning Tree screen. Note that if the entry is already enabled the Disable button will be present; if the entry is disabled, then the Enable button will be present.

72 July 2004 6212-A2-GB20-20