Paradyne Hotwire 8620 GranDSLAM Installation Guide manual Unpacking the Hardware, Package Contents

2. Installation

Unpacking the Hardware

Carefully remove the 8620 chassis from its shipping container and check for physical damage. If the 8620 chassis shows signs of shipping damage, report this immediately to your shipping and sales representatives.

Package Contents

The Hotwire 8620 GranDSLAM chassis, as shipped, consists of the following:

νFour filler plates installed in Slots A, 1, 2, and 3.

νOne SIM card installed in bottom slot.

νOne AC power cord (if your chassis has the AC power option)

νTwo sets of mounting brackets for 19-inch (48.3 cm) and 23-inch (58.4 cm) rack mounting

νAssociated hardware bundled in a plastic bag:

—Set of four rubber feet for desktop mounting

—Four #10-32 mounting screws for mounting in a rack or cabinet

—Four #12-24 mounting screws and four #12-24 self-retaining nuts (for use with racks without threaded mounting holes)

—Four #8-32 Phillips flat-head screws for mounting the 19-inch or 23-inch brackets

—Four cable ties to attach the Tip and Ring cables to DSL cards (should locking pivot brackets not be used)

νAdditional plastic bag with the following to connect Tip and Ring cables to DSL cards:

—Four locking pivot brackets

—Four #4-40 Phillips pan-head, captive screws (to replace longer captive screws when using the rear-mounted connectors)

νFor normal functionality, the Hotwire 8620 GranDSLAM chassis requires:

—An SCP card, or an MCP card and an SCM card

—At least one DSL card

Be sure to register your warranty at www.paradyne.com/warranty.

8620-A2-GN20-40 July 2003 2-3