2. Installation
Hotwire 8620 GranDSLAM Chassis Installation
The Hotwire 8620 GranDSLAM chassis is designed to be placed on a desktop or table, or mounted in a
NOTE:
Do not attach the rubber feet to the chassis if you plan to install it in a rack. The rubber feet will cause the chassis to exceed 3U in height, limiting the maximum number of chassis that can be installed in a rack.
You will need a large
Placing the 8620 Chassis on a Desktop or Table
Procedure
To install the 8620 chassis on a desktop or table:
1.Make sure that the bottom of the chassis is clean so that rubber feet will stick to its surface.
2.Invert the chassis on a protected surface (to avoid scratching the paint).
3.Remove the protective backing from one of the rubber feet and place it in a corner about 1/2 inch (1.27 cm) from each of the edges of the chassis, pressing down firmly to ensure proper bonding.
4.Repeat Step 3 for each of the remaining three feet.
5.Turn the chassis right side up and place on a flat surface where desired.
July 2003 |