Paradyne Hotwire 8620 GranDSLAM Installation Guide Connecting an SCP Card to a Terminal or PC

3. Cabling

6.Tighten the captive screw on the top of the cable’s connector to secure it to the insert mounted on the rear cover.

Tighten Screw

99-16163f-01

7.Plug the Telco 50-pin cable into the appropriate connector for the slot containing the card (labeled 2 or 3, connector 1 is for future use) on the rear of the 8620 chassis.

8.Make sure the other end of the cable is connected to the appropriate POTS splitter shelf, MDF, or demarcation point.

Connecting an SCP Card to a Terminal or PC

Procedure

To connect an SCP card to a terminal or PC:

1.Plug the end of an 8-pin modular cable into SERIAL SCM connector of the SIM, which corresponds to the SCP card in Slot A of the chassis.

2.Plug the other end of the cable into the serial port connector on your terminal or PC.

ALARM A CLOCK B SCM SERIAL MCP SCM LAN MCP

To Terminal Serial Port 03-17433

3.Configure your terminal or terminal emulator with the following settings:

—Baud Rate = 9600

—Data Bits = 8

—Parity = No Parity

—Stop Bits = 1

—Flow Control = None

—Terminal Type = VT100

8620-A2-GN20-40 July 2003 3-5