3. Cabling
Connecting a DSL Card Using Locking Pivot Brackets
Procedure
To connect a DSL card in the 8620 chassis using the provided locking pivot brackets:
1.For each cable, replace the longer captive screw on the cable connector with the
2.Install the locking pivot bracket onto the cable end of the connector using the captive screw, as illustrated below.
Cable with Connector Replace with a shorter Captive Screw provided with the Pivot Bracket
Locking Pivot
Bracket Captive
(Part of Locking Pivot Bracket)
Locking Pivot
Bracket |
3.Insert the bottom edge of the locking pivot bracket inside the lower edge of the rear panel cutout.
| Locking Pivot |
| Bracket |
Rear Panel | Receptacle on Backplane |
Cutout | |
|
4.Align the two connectors.
5.Rotate the connector until it is fully seated.
Rotate
July 2003 |