3. Cabling
Connecting a DSL Card Using Cable Ties
Procedure
To connect a DSL card in the 8620 chassis using the provided cable ties:
1.On each cable, replace the longer captive screw on the cable connector with the
2.Plug the Telco
3.Thread the provided cable tie through the anchor mount on the end of the connector where the cable will lie. Tighten the cable tie around the connector and cut off any excess.
4.Secure the other end of the Telco
5.Make sure the other end of the cable is connected to the appropriate POTS splitter shelf, MDF, or demarcation point.
Cable
Tie
Anchor
Mount
Replaced with
Supplied
Phillips
Screw
Telco
Connector
NOTE:
For detailed information about the POTS splitter, refer to the Hotwire Central
Office Universal POTS Splitter, Models 6050 and 7020, Installation
Instructions.
July 2003 |