Patton electronic 2635, 2621 manual Factory default parameters, General observations

Models 2603, 2621, and 2635 Getting Started Guide About this guide

For AC powered units, ensure that the power cable used with the device meets all applicable standards for the country in which it is to be installed, and that it is connected to a wall outlet which has earth ground.

WARNING

For units with an external power adapter, the adapter shall be a listed Lim- ited Power Source.

WARNING
	Hazardous network voltages are present in WAN ports regardless of whether
	power to the unit is ON or OFF. To avoid electric shock, use caution when near
WARNING	WAN ports. When detaching the cables, detach the end away from the
	device first.

This device contains no user serviceable parts. The equipment shall be returned to Patton Electronics for repairs, or repaired by qualified service personnel.

WARNING

In accordance with the requirements of council directive 2002/ 96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate this product from other waste and scrap and deliver to the WEEE collection system in your country for recycling.

General observations

•Clean the case with a soft slightly moist anti-static cloth

•Place the unit on a flat surface and ensure free air circulation

•Avoid exposing the unit to direct sunlight and other heat sources

•Protect the unit from moisture, vapors, and corrosive liquids

Factory default parameters

IPLink Series High Speed Routers have the following factory default parameters.

•Ethernet IP address: 192.168.200.10/24

•WAN Connection: PPP Bridged

•Ethernet and serial connections

•MDI (LAN connector)

•Model 2621 (X.21)—DB-15 port (DTE)

•Model 2635 (V.35)—DB-25 port (DCE, DTE when using special V.35 cable)

15