Patton electronic 2635, 2621 manual Click on System Configuration IP Routes Create new Ip V4 Route

Models 2603, 2621, and 2635 Getting Started Guide 6 • WAN Services

Figure 39. Frame Relay Channel - Routed configuration

Edit Frame Relay Channel

Enter the appropriate information in the following fields:

•Dlci: Consult with your service provider for the DLCI number required, in this example use 45.

•Encapsulation Method: Defines the RFC1490 encapsulation type that will be used by the channel. Chose the encapsulation method best suited for your network. In this example enter RoutedIp

•RX Max PDU: Enter the number of receive side max PDU, in this example it is the default 8192

•TX Max PDU: Enter the number of transmit side max PDU, in this example it is the default 8192

•Channel segment size. The channel segment size is used to define fragmentation of the packets based on the Frame Relay Forum IA FRF.12. If this variable is set to 0 then FRF.12 “Frame Relay Fragmentation” will be disabled, if set to any other value it will set the fragmentation size used.

•Port: Defines the port that should be used to setup the Frame Relay Connection. For routed applications the port should be set to “frf”. (For bridged applications the port should be set to “fr”.)

9.Click on the Create button.

10.Click on System Configuration > IP Routes > Create new Ip V4 Route

11.Create the gateway to the remote IPLink by entering the WAN IP address of the remote IPLink, in this example, enter 192.168.164.3 in the Gateway field.

The other fields should be:

•Destination: 0.0.0.0

•Gateway: 192.168.164.3

•Mask: 0.0.0.0

WAN Service Configuration 65