S e t t i n g C o m m u n i c a t i o n P a r a m e t e r s

Use the following information if you are connecting to the printer’s 9-pin serial port.

The communication parameters at the printer must match those at the host, or you will not be able to communicate.

You can use the communication settings packet to set communication parameters for your printer.

On MS-DOS computers, you can use the MODE command to set communication values on your PC.

For example

MODE COM1:9600,N,8,1

This command sets your host to these communication values:

a baud rate of 9600

no parity

8 bit word length

1 stop bit

U s i n g P a r a l l e l C o m m u n i c a t i o n s

If your printer supports parallel communications, the parallel port is Centronics® mode. The communication settings are automatically configured for you. There are no operator settings required.

We recommend waiting at least two seconds (or longer) when switching between the serial and parallel ports to send data, because data may be lost. Be careful when using print spoolers, because data transmission occurs in the background of the operating system. This makes data transmission completion difficult to determine when switching between ports.

2-2Configuring the Printer

Page 20
Image 20
Paxar 9416 XL T t i n g C o m m u n i c a t i o n P a r a m e t e r s, I n g P a r a l l e l C o m m u n i c a t i o n s