Manuals
/
Paxar
/
Computer Equipment
/
Switch
Paxar
Monarch 415 manual Toll Free, For supplies, service, or assistance call
Models:
Monarch 415
1
28
28
Download
28 pages
51.01 Kb
21
22
23
24
25
26
27
28
<
>
Troubleshooting
Specs
Connecting Supplies
Setting Up
Remove the flanged collar assembly
Fuse Holder Power Switch Power Cord
For supplies, service, or assistance call
Page 28
Image 28
For supplies, service, or assistance call:
TOLL FREE:
1-800-543-6650
(In the U.S.A.)
1-800-263-4650
(In Canada) www.paxar.com
Page 27
Page 28
Image 28
Page 27
Contents
Operator’s Handbook
Monarch 415 TM Rewind
Paxar is a trademark of Paxar Corporation Monarch Marking Systems
Trademarks
P.O. Box Dayton, Ohio
Table of Contents
Burster Option Setup and Operation
Rewinding on a Paper Core
Stopping
Monarch 415 Rewind Operator’s Handbook
1. Setting Up
Fuse Holder Power Switch Power Cord
Monarch 415 Rewind Operator’s Handbook
2. Connecting Supplies
Rewinding on the Hub
Slide this disk over the hub and against the stock/core Figure
NOTE Units with 3 hubs have a flanged disk instead of a supply guide
Monarch 415 Rewind Operator’s Handbook
Rewinding on a Paper Core
2. Connecting Supplies
5. Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip
3. Operating the Rewind
Starting
Stopping
4. Changing Hubs
To change hubs 1. Pull the supply guide away from the hub Figure
2. Unscrew the hub knob Figure
Supply Guide
3. Remove the hub sections and replace them with the new ones Figure
5. Burster Option Setup and Operation
Separator Bars
10. Position the slot in the hub to the top
12. Slide the separator disk and the next core onto the hub Figure
16. Place the third core over the core lock and slide it onto the hub
5. Burster Option Setup and Operation
Second Separator Disk Notch in Disk Third Core Core Lock
17. Slide the third core against the second separator disk Figure
Label Edge
Second Separator Disk Slot
Monarch 415 Rewind Operator’s Handbook
5. Burster Option Setup and Operation
Opening in Collar
22. Verify that the labels on all three strips are aligned
Supply Removal
2. Remove the flanged collar assembly
5. Burster Option Setup and Operation
1. Remove the core lock metal strip
Monarch 415 Rewind Operator’s Handbook
Specifications
6. Specifications and Supplies
Supplies
Problem
7. Troubleshooting
Corrective Action
Appendix A Rewind Alignment
Location Guide Location Guide Location Guide not available
Location Guide
Location Guide
TOLL FREE
For supplies, service, or assistance call