Manuals / Paxar / Computer Equipment / Switch

Paxar Monarch 415 manual Rewinding on a Paper Core, Connecting Supplies

Models: Monarch 415

1 28

Download 28 pages 51.01 Kb

Page 9

2. Connecting Supplies

2. Connecting Supplies

Rewinding on a Paper Core

1.Slide the supply guide away from the hub flange and pull it away from the hub.

2.Push the paper core on the hub until it is against the hub flange.

3.Hold the hub flange and twist the hub clockwise until the paper core is tight.

4.Tape the supply strip to the paper core (Figure 5). Be sure the supply is against the hub flange.

Hub

Flange

Tape	Supply
	Strip

Paper

Core Hub

Figure 5

5

Image 9

Paxar Monarch 415 manual Rewinding on a Paper Core, Connecting Supplies

Contents

Monarch 415 TM Rewind Operator’s HandbookTrademarks Paxar is a trademark of Paxar Corporation Monarch Marking SystemsP.O. Box Dayton, Ohio Burster Option Setup and Operation Table of ContentsRewinding on a Paper Core StoppingMonarch 415 Rewind Operator’s Handbook 1. Setting Up Monarch 415 Rewind Operator’s Handbook Fuse Holder Power Switch Power CordRewinding on the Hub 2. Connecting SuppliesNOTE Units with 3 hubs have a flanged disk instead of a supply guide Slide this disk over the hub and against the stock/core FigureMonarch 415 Rewind Operator’s Handbook 2. Connecting Supplies Rewinding on a Paper Core5. Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip Starting 3. Operating the RewindStopping To change hubs 1. Pull the supply guide away from the hub Figure 4. Changing Hubs2. Unscrew the hub knob Figure Supply Guide3. Remove the hub sections and replace them with the new ones Figure 5. Burster Option Setup and Operation Separator Bars 10. Position the slot in the hub to the top 12. Slide the separator disk and the next core onto the hub Figure 5. Burster Option Setup and Operation 16. Place the third core over the core lock and slide it onto the hubSecond Separator Disk Notch in Disk Third Core Core Lock Label Edge 17. Slide the third core against the second separator disk FigureSecond Separator Disk Slot Monarch 415 Rewind Operator’s HandbookOpening in Collar 5. Burster Option Setup and Operation22. Verify that the labels on all three strips are aligned 2. Remove the flanged collar assembly Supply Removal5. Burster Option Setup and Operation 1. Remove the core lock metal stripMonarch 415 Rewind Operator’s Handbook 6. Specifications and Supplies SpecificationsSupplies 7. Troubleshooting ProblemCorrective Action Location Guide Location Guide Location Guide not available Appendix A Rewind AlignmentLocation Guide Location GuideFor supplies, service, or assistance call TOLL FREE