Monarch 415 Rewind Operator’s Handbook
3.Remove the hub sections and replace them with the new ones (Figure 11).
a.Slide the new hub spindle on the shaft. Be sure the notch fits over the raised portion of the hub flange.
b.Slide the hub sections on to the shaft with the open ends facing out. The hub section that fits against the hub spindle has two curved grooves instead of peg holes. Be sure the slot in this section is aligned with the smaller side of the hub spindle. Also be sure the slots in the rest of the hub sections are aligned with this section.
c.Slide the hub end on.
NOTE: For a four or six inch long hub, screw on the extension shaft before you install the hub sections.
d.Screw the hub knob on.
Hub
Spindles
Hub
Hub
End
Extension
Shaft
Hub
Knob
Figure 11
10
