Manuals / Paxar / Computer Equipment / Switch

Paxar Monarch 415 manual Appendix A Rewind Alignment, Location Guide

Models: Monarch 415

1 28

Download 28 pages 51.01 Kb

Page 27

Location Guide 113576

Location Guide 113576

Location Guide 113576

Location Guide not available

Location Guide 113576

Location Guide 113580

Location Guide 113576

Appendix A: Rewind Alignment

Location Guide 114664

23

Image 27

Paxar Monarch 415 manual Appendix A Rewind Alignment, Location Guide Location Guide Location Guide not available

Contents

Monarch 415 TM Rewind Operator’s HandbookTrademarks Paxar is a trademark of Paxar Corporation Monarch Marking SystemsP.O. Box Dayton, Ohio Stopping Table of ContentsBurster Option Setup and Operation Rewinding on a Paper CoreMonarch 415 Rewind Operator’s Handbook 1. Setting Up Monarch 415 Rewind Operator’s Handbook Fuse Holder Power Switch Power CordRewinding on the Hub 2. Connecting SuppliesNOTE Units with 3 hubs have a flanged disk instead of a supply guide Slide this disk over the hub and against the stock/core FigureMonarch 415 Rewind Operator’s Handbook 2. Connecting Supplies Rewinding on a Paper Core5. Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip Starting 3. Operating the RewindStopping Supply Guide 4. Changing HubsTo change hubs 1. Pull the supply guide away from the hub Figure 2. Unscrew the hub knob Figure3. Remove the hub sections and replace them with the new ones Figure 5. Burster Option Setup and Operation Separator Bars 10. Position the slot in the hub to the top 12. Slide the separator disk and the next core onto the hub Figure 5. Burster Option Setup and Operation 16. Place the third core over the core lock and slide it onto the hubSecond Separator Disk Notch in Disk Third Core Core Lock Monarch 415 Rewind Operator’s Handbook 17. Slide the third core against the second separator disk FigureLabel Edge Second Separator Disk SlotOpening in Collar 5. Burster Option Setup and Operation22. Verify that the labels on all three strips are aligned 1. Remove the core lock metal strip Supply Removal2. Remove the flanged collar assembly 5. Burster Option Setup and OperationMonarch 415 Rewind Operator’s Handbook 6. Specifications and Supplies SpecificationsSupplies 7. Troubleshooting ProblemCorrective Action Location Guide Appendix A Rewind AlignmentLocation Guide Location Guide Location Guide not available Location GuideFor supplies, service, or assistance call TOLL FREE