Manuals / Paxar / Computer Equipment / Switch

Paxar Monarch 415 manual Connecting Supplies, Rewinding on the Hub

Models: Monarch 415

1 28

Download 28 pages 51.01 Kb

Page 7

2. Connecting Supplies

2. Connecting Supplies

Rewinding on the Hub

1.Slide the supply guide away from the hub flange and pull it away from the hub.

2.Print or feed enough supplies from the printer to wrap around the hub one and one half times.

3.Hold the hub flange and twist the hub clockwise until it stops.

4.Thread the supply strip under the dancer roller.

5.Fold and insert the end of the supply strip into the slot (Figure 3). Be sure the supply is against the hub flange.

Supply

HubStrip

Flange

Slot	Dancer	Supply
Slot	Dancer	Guide
	Roller
	Figure 3

3

Image 7

Paxar Monarch 415 manual Connecting Supplies, Rewinding on the Hub

Contents

Monarch 415 TM Rewind Operator’s HandbookPaxar is a trademark of Paxar Corporation Monarch Marking Systems TrademarksP.O. Box Dayton, Ohio Stopping Table of ContentsBurster Option Setup and Operation Rewinding on a Paper CoreMonarch 415 Rewind Operator’s Handbook 1. Setting Up Monarch 415 Rewind Operator’s Handbook Fuse Holder Power Switch Power CordRewinding on the Hub 2. Connecting SuppliesSlide this disk over the hub and against the stock/core Figure NOTE Units with 3 hubs have a flanged disk instead of a supply guideMonarch 415 Rewind Operator’s Handbook 2. Connecting Supplies Rewinding on a Paper Core5. Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip Starting 3. Operating the RewindStopping Supply Guide 4. Changing HubsTo change hubs 1. Pull the supply guide away from the hub Figure 2. Unscrew the hub knob Figure3. Remove the hub sections and replace them with the new ones Figure 5. Burster Option Setup and Operation Separator Bars 10. Position the slot in the hub to the top 12. Slide the separator disk and the next core onto the hub Figure 16. Place the third core over the core lock and slide it onto the hub 5. Burster Option Setup and OperationSecond Separator Disk Notch in Disk Third Core Core Lock Monarch 415 Rewind Operator’s Handbook 17. Slide the third core against the second separator disk FigureLabel Edge Second Separator Disk SlotOpening in Collar 5. Burster Option Setup and Operation22. Verify that the labels on all three strips are aligned 1. Remove the core lock metal strip Supply Removal2. Remove the flanged collar assembly 5. Burster Option Setup and OperationMonarch 415 Rewind Operator’s Handbook Specifications 6. Specifications and SuppliesSupplies Problem 7. TroubleshootingCorrective Action Location Guide Appendix A Rewind AlignmentLocation Guide Location Guide Location Guide not available Location GuideFor supplies, service, or assistance call TOLL FREE