Manuals / Paxar / Computer Equipment / Switch

Paxar Monarch 415 manual Setting Up

Models: Monarch 415

1 28

Download 28 pages 51.01 Kb

Page 5

1. Setting Up

1. Setting Up

1.Push the 415 Rewind power switch OFF.

2.Place the rewind on a level surface. Be sure it is at least ten inches away from the supply exit of the printer (Figure 1).

3.Squarely align the rewind’s hub flange with the edge of the supply. See Appendix A, "Rewind Alignment."

Hub

Flange

	Printer
	Supply
Hub	Exit
Hub

Power

Switch

Figure 1

1

Image 5

Paxar Monarch 415 manual Setting Up

Contents

Monarch 415 TM Rewind Operator’s HandbookP.O. Box Dayton, Ohio TrademarksPaxar is a trademark of Paxar Corporation Monarch Marking Systems Burster Option Setup and Operation Table of ContentsRewinding on a Paper Core StoppingMonarch 415 Rewind Operator’s Handbook 1. Setting Up Monarch 415 Rewind Operator’s Handbook Fuse Holder Power Switch Power CordRewinding on the Hub 2. Connecting SuppliesMonarch 415 Rewind Operator’s Handbook NOTE Units with 3 hubs have a flanged disk instead of a supply guideSlide this disk over the hub and against the stock/core Figure 2. Connecting Supplies Rewinding on a Paper Core5. Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip Starting 3. Operating the RewindStopping To change hubs 1. Pull the supply guide away from the hub Figure 4. Changing Hubs2. Unscrew the hub knob Figure Supply Guide3. Remove the hub sections and replace them with the new ones Figure 5. Burster Option Setup and Operation Separator Bars 10. Position the slot in the hub to the top 12. Slide the separator disk and the next core onto the hub Figure Second Separator Disk Notch in Disk Third Core Core Lock 5. Burster Option Setup and Operation16. Place the third core over the core lock and slide it onto the hub Label Edge 17. Slide the third core against the second separator disk FigureSecond Separator Disk Slot Monarch 415 Rewind Operator’s HandbookOpening in Collar 5. Burster Option Setup and Operation22. Verify that the labels on all three strips are aligned 2. Remove the flanged collar assembly Supply Removal5. Burster Option Setup and Operation 1. Remove the core lock metal stripMonarch 415 Rewind Operator’s Handbook Supplies 6. Specifications and SuppliesSpecifications Corrective Action 7. TroubleshootingProblem Location Guide Location Guide Location Guide not available Appendix A Rewind AlignmentLocation Guide Location GuideFor supplies, service, or assistance call TOLL FREE