S Y M B O L S E T S / C O D E P A G E S C

This appendix contains a listing of the symbol sets, code pages, and extended character sets the printers support.

Use the charts in this appendix to convert dot sequences from the image dot pattern to codes you can use in the fields. Use the Binary to Hex Conversion Chart to convert Binary dot sequences to Hexadecimal numbers for bitmap files. Use the Dot to Run Length Encoding Chart to convert dot sequences to alphabetic characters for bitmap files.

S u p p o r t e d S y m b o l S e t s a n d C o d e P a g e s

The printer supports these symbol sets and code pages: Internal, ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850. Additional Code Pages are supported with downloaded TrueType or Unicode (double-byte) fonts.

The printer defaults to the internal symbol set.

Note: Fonts 1004, 1005, 1010, and 1011 are limited to the following special characters: 0123456789#$%&(),./@DFKLMPS\kprö¢£¥. These fonts do not support the full ANSI character set and some characters above decimal value 127 are substituted.

S e l e c t i n g a S y m b o l S e t o r C o d e P a g e

The CG Triumvirate™ typefaces support only the ANSI and DOS Code Page 437 and 850 Symbol Sets. These fonts print a slashed zero when using the ANSI symbol set.

Internal

Use this symbol set to print international monetary

 

symbols, the trademark (™) symbol, and for formats that

 

may be used on other MPCLII printers.

ANSI

Use this symbol set with proportionally spaced

 

fonts.

DOS Code

Use this symbol set for extended and international

Pages 437 or 850 characters with proportionally spaced fonts.

Symbol Sets/Code Pages C-1

Page 147
Image 147
Paxar TC6037PR P p o r t e d S y m b o l S e t s a n d code P a g e s, L e c t i n g a S y m b o l S e t o r code P a g e