Paxar TC6037PR manual C h i n e Fault s

Models: TC6037PR

1 188
Download 188 pages 30.02 Kb
Page 100
Image 100
Magnification must be 1 - 7 or 4 - 250 for the scalable font.

615Bar code width is greater than 16 inches, or number of keywords for PDF 417 exceeds 928. Decrease the density or shorten the amount of data to print the bar code.

616Dot shifting failed. A bad dot falls on a bar code that cannot be shifted. Call Technical Support.

618

621An error occurred opening the TrueType font file. Select a different font to download. If the error message persists, call Technical Support.

622Not enough memory to create the downloaded TrueType characters in the scalable (vector) fonts buffer. Reconfigure the printer’s memory and increase the scalable (vector) fonts buffer. Resend the font, format, and batch packet after reconfiguring the memory. If the error message persists, call Technical Support.

M a c h i n e F a u l t s

These errors occur when there is a problem with the printer.

703The printer sensed a calibration of different-sized black marks. Make sure the correct supply is loaded.

704Printer has not sensed a supply mark within the specified number of inches or is out of supplies. Check the supply tracking, supply marks, black mark sensor position, and supply roll for binding.

Change supply.

706The motor could not get up to speed within the allotted time. Call Technical Support.

707The motor reached the desired speed, but was unable to maintain that speed. Call Technical Support.

708The motor has stalled or is running too slow to measure the speed. Call Technical Support.

750Printhead is overheated. Turn off the printer to let the printhead cool. If the error persists, call Technical Support.

6-14Troubleshooting

Page 100
Image 100
Paxar TC6037PR manual C h i n e Fault s