22
SunTouch Pool and Spa Control System Installation and User’s Guide
Advanced Menu (8/13): Pool/Spa Delays
The pool and spa delays feature allows you to assign a delay function to the following equipment.
•Heater Cool-Down Delay Cancel: Shuts Filter Pump off immediately.
Some heaters require a cool-down cycle before being switched off. This can be setup to run the filter
pump an additional ten minutes to dissipate residual heat built up inside the heater combustion
chamber. You can also cancel the delay feature. For information about using the cancel delay feature,
refer to “Delay Cancel” on page 16.
•2-Speed Filter Pump five (5) minute START on HIGH SPEED Delay Cancel: Shifts pump to
low speed.
•Automatic Pool Cleaner START Delay: Starts Cleaner Pump immediately, without normal delay in
which the filter pump first runs for five (5) minutes.
•Automatic Pool Cleaner SOLAR Delay: Allows Cleaner Pump to run even though the solar delay
has shut it off for five (5) minutes.
Delays
To assign the delay feature:
Menu button: Select the Advanced menu.
Right button: Select the pool and spa delay setting.
Up/Down buttons: Select Yes to enable or No to disable delays for the pool and spa
circuits.
Left button: Press the Left button to return to the main status screen.
Advanced Menu (8/13): Temp Units - F° / C° (Fahrenheit/Celsius)
The temperature settings for the water, solar and air can be displayed in either Fahrenheit or Celsius on the
Main screen.
Fahrenheit/Celsius
To change the temperature units:
Menu button: Select the Advanced menu.
Right button: Select the Fahrenheit or Celsius setting.
Up/Down buttons: Select either Fahrenheit or Celsius units for temperature settings
displayed on the Main screen.
Left button: Press the Left button to return to the main status screen.
HeaterDelay
Enabled: Yes
Main Menu 8/13
Advanced
Temp Units
[FAHRENHEIT ]
Main Menu 8/13
Advanced