28
SunTouch Pool and Spa Control System Installation and User’s Guide

Settings Menu (11/13): QuickTouch® (QT4) Wireless Remote

The QuickTouch QT4 wireless remote controller provides switching of up to four circuits. For example, you
can use the QT4 wireless remote to activate the spa circulation, and for operating three auxiliary pieces of
equipment (such as heat enabled, lights, jet pump, heat boost, air blower, waterfall, etc.).
Each of the four functions on the QT4 wireless controller has an on and an off button. To switch a circuit on
or off, press and hold the appropriate button for at least a full second.
The QT4 buttons can be assigned to any available circuit. However, the QT4 has the following preset circuits
assigned to the four buttons:
• The SPA button activates the spa circuit (same an the Up button on the SunTouch control panel.)
• A button activates the AUX 1 circuit.
• B button activates the AUX 2 circuit.
• C button activates the AUX 3 circuit.
Assign QT4 buttons
To assign circuits to the QuickTouch wireless controller buttons:
Menu button: Select the QuickTouch menu.
Right button: Assign the SPA button to a circuit.
Up/Down buttons: Choose a circuit to assign to the SPA button. The circuit
selections are: None, Spa, Pool, AUX 1, AUX 2, AUX 3, SOLAR, HEAT BOOST,
HEAT ENABLED. Selecting “None” does not assign a circuit.
Note: The “Heat Boost” feature will switch on the heater for seven minutes to
increase the spa water temperature. Each time the spa Heat Boost button is
pressed, the temperature will increase about 1° F. The temperature will not go
beyond the 104° F (40° C) limit.
Right button: Assign button A to a circuit 1. Use the Up/Down buttons to select a
circuit for button A. Repeat the process for Buttons B (AUX 2 circuit 2) and C (AUX
circuit 3).
Left button: Press the Left button to return to the main status screen.
AQuickTouch
2 - [POOL ]
QuickTouch
3 - [AUX1 ]
Main Menu 11/13
QuickTouch
QuickTouch
1 - [HEAT BOOST]
QuickTouch
SPA - [SPA ]