75
SunTouch Pool and Spa Control System Installation and User’s Guide
Installing the ESO Circuit Board (Continued)
6. Connecting the ESO switch: Route a two-wire cable through grommet located on the left-side of
the SunTouch Power Center, up into the low voltage raceway to the ESO switch circuit board.
7. Connect the two wires to J13 on the ESO switch circuit board. Connect the other end of the cable to
the emergency switch as shown below.
8. Verify that all cable connections are connected correctly. Close the front panel and secure it with the
retaining screw. The Emergency Shut-Off Switch installation is complete.
Grommet
(Low voltage raceway)
Emergency shut-off
circuit board
Emergency Shut-Off switch (ESO)
A
B
C
D
E
F
SHUT OFF
+ -
A
B
C
D
E
F
J13
SunTouch Power Center
2-wire connection