64
SunTouch Pool and Spa Control System Installation and Users Guide
Self Test Error Codes
The “Self Test” feature is intended for use by service personnel. If after performing a control panel self test
(see Diagnostics menu page 25) there were no errors detected, Code 0 is displayed, indicating that there were
no problems and the test was successful. If a problem is detected during the test, an error code is displayed
upon completion of the test. For example Code 1 would indicate a problem with the display. If multiple errors
are detected, multiple code numbers are displayed. For example, Codes 4, 2, 1, would indicate problems
detected with the buttons, LCD contrast, LCD backlight on the control panel.
The following lists the control panel self test error codes.
Error Code Table

SunTouch Error Messages

Error Messages
If the system detects that a sensor is not connected to the SunTouch Power Center or it is defective, an error
message is displayed in the Diagnostics menu (page 25). The following lists the sensor errors.
egasseMrorrEesuaCelbissoPnoituloS
niaMehtnosyalpsiD(rrEriA
)neercS
ehtotdetcennoctonrosnesriA
.draobrehtomh
cuoTnuS
12JotdetcennocsigulprosnesriaehttahtkcehC
rosnesehttahtkcehC.draobrehtomehtnorotcennoc
.ylreporpdetcennocsieriw
nisyalpsiD(rrEerutarepmeTriA
)unem"scitsongaiD"eht
ehtotdetcennoctonrosnesriA
.draobrehto
mhcuoTnuS
12JotdetcennocsigulprosnesriaehttahtkcehC
.draobrehtomehtnorotcennoc
syalpsiD(rrEerutarepmeTre
taW
)unem"scitsongaiD"ehtni
otdetcennoctonrosnesretaW
.draobrehtomhcuoTnuSeht
12JotdetcennocsigulprosnesretawehttahtkcehC
.draobrehtomehtnorotcennoc
syalpsiD(rrEerutarepmeTraloS
)unem"scitsongaiD"ehtni
otdetcen
noctonrosnesraloS
.draobrehtomhcuoTnuSeht
12JotdetcennocsigulprosnesralosehttahtkcehC
.draobrehtomehtnorotcennoc
edoCrorrEnoitpircseD
0edoCsahlenaplortnocehT-SSAP
smelborpon
1edoCthgilkcabDCL
2edoCtsartnocDCL
4edoC)snottub(h
ctiwS
5edoCtsetkcabpoolTRAU

Resetting the System Fuses

The SunTouch Power Center provides two resettable fuses to protect the 18 VAC and 24 VAC circuits. The

fuses are located on the front panel of the SunTouch Power Center. Press the fuse button to reset the fuse. See

page 40 for fuse locations.