32
SunTouch Pool and Spa Control System Installation and Users Guide

IntelliChlor Menu (13/13): Status and Error Messages

If an error alert, or warning is detected by IntelliChlor, the error message will be displayed on the SunTouch
control panel screen. All status and error messages can be viewed from the IntelliChlor menu. For
troubleshooting information, refer to the IntelliChlor Electronic Chlorine Generator Users Guide (P/N 520589).
To view the IntelliChlor status and error messages:
Menu button: Select the IntelliChlor menu.
Right button: Press the button until the Salt status screen is displayed.
Displays the current IntelliChlor chlorination system status.
Left/Right button: Press the Left or Right button to return to the main status
screen.
IntelliChlor status and error messages:
SALT LEVEL: Displays the current salt level. Values from 0 to 12750 ppm in 50 ppm
increments.
IntelliChlor Status and Error messages:
SUPER CHLORINATE: IntelliChlor is in Super Chlorination mode. For information
COM LINK ERROR: Check cable from IntelliChlor to SunTouch motherboard.
Check FLOW/PCB: Check IntelliChlor electrolytic cell controller. Refer to IntelliChlor
Users Guide troubleshooting information.
LOW SALT: Add salt to pool water. The water salt level is between 2500 ppm and
2950 ppm. The IntelliChlor will continue to produce chlorine at a reduced level.
VERY LOW SALT: Not enough salt in pool. The water salt level has fallen below 2500
parts per million (ppm). IntelliChlor will not produce chlorine until additional salt is
added manually.
HIGH CURRENT: Check IntelliChlor electrolytic cell controller. Refer to IntelliChlor
Users Guide troubleshooting information.
CLEAN CELL!!: Cell has calcium build up and requires cleaning. Refer to IntelliChlor
Users Guide for cleaning instructions.
LOW VOLTAGE: Check IntelliChlor electrolytic cell controller. Refer to IntelliChlor
Users Guide troubleshooting information.
OK - NO ERRORS: IntelliChlor is in normal operating mode.
About Super Chlorination: The Super Chlorination feature is used to introduce large amounts of chlorine
into the pool water if there has been heavy rain fall, many bathers in the pool, cloudy water conditions, etc.
When Super Chlorination is enabled, the system will switch on the filter pump, set the pool/spa valves to the
correct position, and set the IntelliChlor chlorine generator to maximum output. This process continues for 24
hours. At the end of the Super Chlorination process, the pool will return to normal operation. It is possible to
manually stop the Super Chlorination process and switch off the filter pump in the “Circuit On/Off” menu
(see page 13). When the filter pump is switched on again, the Super Chlorine process will resume for the
duration of time left.
Main Menu 13/13
IntelliChlor
Salt: 3200 ppm
[OK - NO ERRORS]