71
SunTouch Pool and Spa Control System Installation and User’s Guide
Wiring SunTouch to the InteliiChlor Salt Chlorine Generator
Be sure to check the wire color and function of the IntelliChlor salt chlorine generator before connecting it to the
SunTouch COM port on the motherboard. See the wiring table below for the pin configuration.
Failure to wire the salt chlorine generator properly can permanently damage the SunTouch system or chlorine
generator. See “IntelliChlor Menu (13/13) on page 31 for setup information.
Wiring Description (SunTouch to IntelliChlor)
gniriwtropMOChcuoTnuS
noitcennocroloc
noipircseDenirolhCtlaSrolhCilletnI
rotareneG
DERCDV51+DER
WOLLEYATAD+KCAL
B
NEERGATAD-WOLLEY
KCALBDNUORGNEERG
• Power: 95 VAC to 135 VAC, 0.82 AMP 50/60 Hz. or 192 VAC to 288 VAC, 0.41 AMP 50/60Hz
• Valve Actuator Output: 24VAC, 50/60 Hz. 0.65 AMP maximum (3 pin connector)
• Relay Outputs: 3HP@240V, 1.5HP@120V, booster pump, pool sweep interlock, filter pump or lights.
Three (3) relays provided.
• Sensors (thermistor type, 10K Ω 77° F (25° C). Two sensors required for solar and pool
temperatures. Freeze protection requires an additional sensor for air temperature.
• Start Temperature Differential (Solar): 3° - 9°
• Stop Temperature Differential (Solar): 2° - 5°
• Set Temperature limit: 40° F to 104° F (4° C to 40° C) calibrated scale
• Freeze Protection: On at 35° F, off at 38° F