Turn the flash unit on the camera on.

00_AF360FGZ.book Page 48 Tuesday, June 13, 2006 12:09 PM

5 Set the zoom position to suit the subject and place the flash unit at the desired location.

When setting up a flash unit separately from the camera, use the off-camera shoe adapter F when using a tripod, or the off-camera shoe clip CL-10 when setting up in another location such as

6tabletop, chair, etc.

If the camera's built-in flash unit is part of the combination, pop up the built-in flash unit.

7 Check that the ready lamp is lit, then take the picture.

When charging is complete, ( ) is lit in the viewfinder of the camera.

The ready lamp is lit on the AF360FGZ.

Position the slave unit(s) so that the slave sensor can receive the flash fired by the camera’s built-in flash unit or attached flash unit.

The AF360FGZ will fire at the same time that the camera’s flash fires.

Keep the distance from the built-in flash unit and AF360FGZ to the subject within 4 meters.

The slave unit will turn off automatically after about 1 hour of non-operation when the auto power off function is set.

Do not use red-eye reduction with the camera’s flash. This will result in the AF360FGZ firing by the pre-flash. For the same reason, set the camera to manual focus when firing the flash continuously so that the AF spotbeam does not operate with cameras that have AF spotbeam functions.

48

Page 50
Image 50
Pentax AF-360FGZ manual Check that the ready lamp is lit, then take the picture