Remote Controller
• Applicable Model
Remote controller
Install the remote controller according to the instructions in the Installation Guide (p. 28).
*The water heater has been factory set to allow a maximum temperature setting of 50°C (122°F). To access higher temperature settings through the remote controller, follow the below steps.
<When setting the maximum temperature to
1.Turn the water heater off by pressing the ON/OFF button on the remote controller.
2.Press and hold the FLOW METER ALARM SET button until a sound is heard (2 sec.) and 50°C (122°F) appears on the display.
3.Set the upper limit of the
4.To put the water heater back into operation, press the ON/OFF button on the remote controller. To keep the water heater off, let the unit sit for 30 sec. to return to the original display.
<When setting the maximum temperature to |
| |
1. | Turn the water heater off by pressing the ON/OFF button on the remote |
|
| controller. |
|
2. | Disconnect electrical power to the water heater. | TOR |
NNEC | ||
CO | ||
TEMPERATURE |
3. | Remove the front cover of the water heater (4 screws). | STMENT |
TER | ||
ADJU | ||
WA | ||
| ||
4. Connect "WATER TEMPERATURE ADJUSTMENT CONNECTOR" tag |
| |
| connector to "180°F" tag connector as shown on the right. |
|
5. | Replace the front cover of the water heater (4 screws). |
|
6. Reconnect electrical power to the water heater, but do not turn it on. |
| |
7. | Press and hold the FLOW METER ALARM SET button until a sound is (the back : 55 C) (the back : 60 C) | WATER TEMPERATURE |
ADJUSTMENT CONNECTOR |
heard (2 sec.) and 50°C (122°F) appears on the display. | (the back : 83 C) |
|
8.Set the upper limit of the
55°C (130°F), 60°C, 65°C, 70°C, 75°C (140°F, 149°F, 158°F, 167°F) or 83°C (180°F) using the UP and DOWN setting buttons.
9.To put the water heater back into operation, press the ON/OFF button on the remote controller. To keep the water heater off, let the unit sit for 30 sec. to return to the original display.
•The
temperature, connect the temperature selection wire as shown in the above diagram. The default tem- perature is 50°C (122°F) when the temperature selection wire is not connected.
WARNING
•When changing the temperature, make sure to confirm with the customer that the temperature of the hot water will be very high and that there is a risk of scalding.
•Water temperatures above 52°C (125°F) can cause severe burns or death from scalding.
21