Pentax N-0751M-OD installation manual For outdoor installation only

[For outdoor installation only]

Installing the Remote Controller Outdoor Junction Box

1. Insert the remote controller wires through the		5.	Slide the box nut over the remote controller
wall pipe and secure the wall pipe to the			wires and screw it onto the wall pipe.
remote controller. Locate the remote controller
wall packing, slide it over the pipe and wires,			Wall Pipe
and apply it to the rear side of the remote.
Rear side of remote controller			Box Nut
			Remote
	Wall Packing		Controller
Secure the wall pipe			Wires
firmly into the remote
controller.
Take off the
paper.
2. Drill a 32mm ( 1-1/4") hole in the wall		6.	Connect the remote controller wires to the
where the remote controller will be installed.			separate remote controller cord inside the box.
			Wind the excess remote controller wire on the
* Do not install the remote controller in a			provided hooks as illustrated below.
location that is exposed to moisture, direct			(Wind the
sunlight, or chemical agents. These can			excess wire
damage the remote controller.			here.)
			Remote Controller
			Wires
3. Insert the wall pipe containing the remote			Junction Box
controller wires through the hole.
4. Slide the junction box packing and the junction			Remote Controller
box over the remote controller wires and wall
			Cord
pipe protruding from the outside wall.
Wall packing	Wall pipe
	Take out the pipe about		Tie the redundant length of the remote
	18.75mm (3/4") from		controller cord outside the junction box.
	the wall.
	Junction Box	7. Close the junction box.
	Box Nut
	Remote
	Controller
	Wires
Take off the paper.
	Junction Box Packing

30